@

F-50 U-50 ‚ΜŽd—l

@

Sensor Specifications	F-50	U-50
Imager Type	CMOS integrating active pixel sensor(APS), With on-chip uniformity correction
Sensor type	Monochrome
Resolution	1280 X 1024
Region of Interest(ROI)	Any rectangle or line image format specified by the user
Active image area	8.58mm(H) x 6.86mm(V)
Pixel pitch / Fillfactor	6.7 x 6.7 ƒΚm / 50%(no microlenses)@
Spctral response	better than 25%
Temporal noise	<40 electrons
Well Capacity	63000 electrons (100000 full saturation
Dark current signal	410 electrons/second @ 21‹C
AveDauto-saturation time	160 seconds @ 21‹C
Dark current	255pA/cm2 @21Ž
Smear	None
Standard dynamic range	64 dB
High dynamic range	80 dB to 100dB in Multi-Slope Exposure (up to 4 slopes programmable)
Gray level resolution	8 bits / 10 bits / 12bits
Image Specifications
Pixel rate	40 MHz
Frame rate	Full resolution approx. 27.5 frames/second (Rolling shutter mode)
Shutter	Synchronous type (Snapshot) and Rolling shutter
Shutter synchronisation	Remote via software or via cable, local via I/Ointerface
Maximum Exposure time	200 seconds
Minimum exposure time	10 ƒΚsec@
Interface Specifications	F-50	U-50
intrerface type	IEEE-1394 Firewire	USB 2.0
Interface connector	Standard. 6-pole	Binder 712 series 4-pole
Cable lengths	max 4.5m	5m
Local Trigger	Isolated, 1 input, 1 output	Isolated, 1 input, 1 output
Local Trigger Connector	Binder 712 series 3-pole	Binder 712 series 3-pole
Mechanical
Dimensions	51 x 51 x 57 mm	51 x 51 x 57 mm
Weifht	220g	205g
Mounting	8 x M4 threaded holes 2 holes on 4 sides of unit)	8 x M4 threaded holes 2 holes on 4 sides of unit)
Power
Voltage	Power Supply via Firewire cable	Power Supply via USB cable
Power Consumption	<2W	<2W
Environmental
Operating Temperature	@0‹ to 50‹C , Humidity: 10-90%, non-condensing
Storage	-30‹ to 80‹C, Humidity: 10-90%, non-condensing

@

[(Š”j΅Μίèς֖⍇‚Ή]